Indent feature help
Indent feature help
(OP)
Ok, I've been reading the help on Indent and trying to figure out how to use it and I know I'm not seeing something. I'd like to indent the flat sheet shown in the attachment with the pointed tool, but nothing happens when I pick the sheet as target and the point as the tool. If I make the tool contact the sheet like help says then I only have one solid body and that doesn't work, either. Does someone know of a good tutorial on this or can slap me around so I can understand the how-to?? Much obliged in advance.






RE: Indent feature help
Also in your case, unselect the Merge option when creating the intersecting flat sheet.
RE: Indent feature help
Next you can use "Thicken" tool to add thickness to indented sheet.
Artem Taturevich, CSWP
Software and Design Engineer
AMCBridge LLC
www.amcbridge.com
RE: Indent feature help
P.S. Roll to end and unsuppress the features
Deepak Gupta
SW2009 SP3.0
SW2007 SP5.0
MathCAD 14.0
RE: Indent feature help
RE: Indent feature help
Deepak Gupta
SW2009 SP3.0
SW2007 SP5.0
MathCAD 14.0