Hose Barb Geometric Standards
Hose Barb Geometric Standards
(OP)
I am modeling up a brass 1/2" elbow hose connector with barbed ends. Does anyone have a model or a set of standards so I get the dimensions correct for the barbed portions?
Thanks
Thanks





RE: Hose Barb Geometric Standards
http://www.thogus.com/elbows.htm
David Baird
Sr Controls Designer
EET degree.
Journeyman Electrician.
RE: Hose Barb Geometric Standards
http://www
You may have to just fake the barbs. You will get close with the hose mender on page G10.
Ted