A part with features that cannot be unbent
A part with features that cannot be unbent
(OP)
i have a sheetmetal part which has a bend that i need to unbend. When i use the unfold command it tells me that i have a part with features that cannot be unbent. Specifically the bend that i want to unbend. Does anyone know why this is happening and what the solution is?






RE: A part with features that cannot be unbent
RE: A part with features that cannot be unbent
RE: A part with features that cannot be unbent
We need to know what features are involved to know what might be preventing the unfold function.
Use the ...or upload your file to ENGINEERING.com link below to post an image of the part, or the part itself.
RE: A part with features that cannot be unbent
RE: A part with features that cannot be unbent
Diego
RE: A part with features that cannot be unbent