Importing Inventor assemblies into SW2009
Importing Inventor assemblies into SW2009
(OP)
When I try to open an Inventor assembly in Solidworks all of the Inventor parts are replaced by the Inventor assembly base part. If I have one base plate and five other parts in the Inventor assembly, I get 6 base plates in place of all the original parts. Anyone have this problem?






RE: Importing Inventor assemblies into SW2009
Colin Fitzpatrick (aka Macduff)
Mechanical Designer
Solidworks 2009 SP 3.0
Dell 490 XP Pro SP 2
Xeon CPU 3.00 GHz 3.00 GB of RAM
nVida Quadro FX 3450 512 MB
3D Connexion-SpaceExplorer
RE: Importing Inventor assemblies into SW2009