New part appearance in assemblies
New part appearance in assemblies
(OP)
Since switching to 2009 I have noticed that when I drop a part into an assembly its appearance is always shaded w/o edges, even though the rest of the assembly is shaded w/ edges. To get edges back on my new part I have to open the part and rebuild it. Its not a big problem, just kind of annoying - is anyone else experiencing this?






RE: New part appearance in assemblies
Dan
www.eltronresearch.com
Dan's Blog
RE: New part appearance in assemblies
RE: New part appearance in assemblies
RE: New part appearance in assemblies