checking shaft or pin surface element straightness
checking shaft or pin surface element straightness
(OP)
hi,
im new here. would appreciate thoughts on best way to inspect straightness of line elements of a pin or shaft. my assumption is to run an indicator along the pin length at various points around circumference but whats best way to keep indicator tip from running off course?
im new here. would appreciate thoughts on best way to inspect straightness of line elements of a pin or shaft. my assumption is to run an indicator along the pin length at various points around circumference but whats best way to keep indicator tip from running off course?





RE: checking shaft or pin surface element straightness
Powerhound, GDTP T-0419
Production Manager
Inventor 2009
Mastercam X3
Smartcam 11.1
SSG, U.S. Army
Taji, Iraq OIF II