Ground Grid Study
Ground Grid Study
(OP)
I am performing a ground-grid study using ETAP, but am not able to understand how it works. Called the ETAP tech support, but could not get information. My main problem is how to enter data in the ground-grid and how to link the ground-grid to the single line. In other words how to enter the bus-ratings, short-circuit-currents, motor-HP, etc into the ground grid. Your help in this matter will be highly appreciated.






RE: Ground Grid Study
The short answer is after reading IEEE 80,please follow a training course on ETAP.
I think this had been advised several times by our most members.In my opinion, this forum is not the place for your requirement.
Hope this helps.