Cycle times
Cycle times
(OP)
After post processing a program in NX 6.0
is there a way for the software to give me an aprox.
cycle time?
is there a way for the software to give me an aprox.
cycle time?
INTELLIGENT WORK FORUMS
FOR ENGINEERING PROFESSIONALS Come Join Us!Are you an
Engineering professional? Join Eng-Tips Forums!
*Eng-Tips's functionality depends on members receiving e-mail. By joining you are opting in to receive e-mail. Posting GuidelinesJobs |
|
RE: Cycle times
Attached is a custom command that you can add to the end of path event. This will output the run time for each operation and the total time. I did not write this code it was given to me.
Good luck
John Joyce
Tata Technologies
1675 Larimer St.
Denver, CO
www.myigetit.com
NX3,4,5,6 Solid Works, Pro/e, Solid Edge