surface alignment...nx4
surface alignment...nx4
(OP)
I need to model a face that transitions between a rectangular face and an elipse. It seems easy enough, but I can not get the surface to align properly. I've tried different creation methods, and tried the different alignment options, but can't seem to get it to work. Thank you for any advise you can give me. NX4.0.0.25.





RE: surface alignment...nx4
I'll take a look at it for you later if no one responds back
RE: surface alignment...nx4
RE: surface alignment...nx4
RE: surface alignment...nx4
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Cypress, CA
http://www.siemens.com/plm
http://www.plmworld.org/museum/
To an Engineer, the glass is twice as big as it needs to be.