Rename Active Configuration Macro Request
Rename Active Configuration Macro Request
(OP)
Has anyone created a macro to rename the active configurations and display the document name in the BOM? Prior practice was to name them the same as the part number however as these parts are used for new parts people tend to overlook the renaming part. Thanks






RE: Rename Active Configuration Macro Request
Matt Lorono
CAD Engineer/ECN Analyst
Silicon Valley, CA
Lorono's SolidWorks Resources
Co-moderator of Solidworks Yahoo! Group
and Mechnical.Engineering Yahoo! Group
RE: Rename Active Configuration Macro Request
RE: Rename Active Configuration Macro Request
http:
http:
RE: Rename Active Configuration Macro Request
I prefer a macro because it allows the less experienced people a simple solution to an ongoing issue, also i prevents 20 different ways to spell "default"