NX5 some edges don't appear in drafting ISO views
NX5 some edges don't appear in drafting ISO views
(OP)
Reference: thread561-156671: NX2 iso views dont show all the lines
Has anything been updated in NX 5 or 6 regarding this issue? We currently have this problem in some of our drawings, tried toggling silhouetes, interfering solids, and virtual intersections all with no luck. The tolerance setting on the general tab is always a mystery to me. Sometimes increasing the tolerance makes the view look better, other times worse.
Has anything been updated in NX 5 or 6 regarding this issue? We currently have this problem in some of our drawings, tried toggling silhouetes, interfering solids, and virtual intersections all with no luck. The tolerance setting on the general tab is always a mystery to me. Sometimes increasing the tolerance makes the view look better, other times worse.





RE: NX5 some edges don't appear in drafting ISO views
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Cypress, CA
http://www.siemens.com/plm
http://www.plmworld.org/museum/
To an Engineer, the glass is twice as big as it needs to be.