Assembly Level Cut Question
Assembly Level Cut Question
(OP)
Hello All,
I have an assembly where I needed to add some cut features to a part at the assembly. This was no issue but when I mirror the part over the top plane it does not mirror the cut features, only the part before the features were added. Is there a way to include the assembly level cut features in the mirror?
Thanks,
BB
I have an assembly where I needed to add some cut features to a part at the assembly. This was no issue but when I mirror the part over the top plane it does not mirror the cut features, only the part before the features were added. Is there a way to include the assembly level cut features in the mirror?
Thanks,
BB






RE: Assembly Level Cut Question
Dan
www.eltronresearch.com
Dan's Blog
RE: Assembly Level Cut Question
I am using SW2008 SP5.0 What is the procedure to do the propagation?
Thanks,
BB
RE: Assembly Level Cut Question
Dan
www.eltronresearch.com
Dan's Blog
RE: Assembly Level Cut Question
RE: Assembly Level Cut Question
Thanks all