NX5, Cavity mill, tool axis???
NX5, Cavity mill, tool axis???
(OP)
Ok, I feel silly asking this, but here goes.
Can you specify a tool axis in cavity mill?
Am I just missing it? I've been programming for ages, but I don't think I have ever run into this issue.
And, if the answer is "No, you cannot specify a tool axis" then why the heck not?
Thanks,
JAY
Can you specify a tool axis in cavity mill?
Am I just missing it? I've been programming for ages, but I don't think I have ever run into this issue.
And, if the answer is "No, you cannot specify a tool axis" then why the heck not?
Thanks,
JAY





RE: NX5, Cavity mill, tool axis???
I figured it out.
It seems that the dialog option for tool axis was turned off.
I knew it was there somewhere!
JAY
RE: NX5, Cavity mill, tool axis???
if any probs, contact me