Updating the model from a drawing (NX5)
Updating the model from a drawing (NX5)
(OP)
I cannot find a method of storing a value in a table on a drawing and allowing this value to change a feature on the model. For instance changing a length by changing the number.
I can change the feature and show the change in the box on the drawing, but I can't reverse the process.
Any help with this problem would be greatly appreciated.
Thanks in advance.
I can change the feature and show the change in the box on the drawing, but I can't reverse the process.
Any help with this problem would be greatly appreciated.
Thanks in advance.





RE: Updating the model from a drawing (NX5)
Tim Flater
Senior Designer
Enkei America, Inc.
www.enkei.com
Some people are like slinkies....they don't really have a purpose, but they still bring a smile to your face when you push them down the stairs.
RE: Updating the model from a drawing (NX5)
I am new in UG/NX, an old ProE lag (spit, spit). Any help is a boon for me.
Thanks.
RE: Updating the model from a drawing (NX5)
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Cypress, CA
http://www.siemens.com/plm
http://www.plmworld.org/museum/
To an Engineer, the glass is twice as big as it needs to be.
RE: Updating the model from a drawing (NX5)