UG NX3 Error
UG NX3 Error
(OP)
Can anybody help me.
I am using NX3 and I having the below problem.
Did anybody have some solution how to solve the problem/error.
Thanks
*** EXCEPTION: INTERNAL ERROR in line 6478 of D:\ugnx30\sandbox\src\part\no\ind\part_load.c
I am using NX3 and I having the below problem.
Did anybody have some solution how to solve the problem/error.
Thanks
*** EXCEPTION: INTERNAL ERROR in line 6478 of D:\ugnx30\sandbox\src\part\no\ind\part_load.c





RE: UG NX3 Error
What version of NX ?
Best Regards
Hudson
www.jamb.com.au
Nil Desperandum illegitimi non carborundum
RE: UG NX3 Error
it looks like you are using NX in a sandbox, is there enough space in your sandbox to fully load the assembly. There is a limit of about 1.5GB of space preserved in a sandbox.
Hope this helps,
kind regards
Michaël
RE: UG NX3 Error
I am still searching the sandbox.
Can you advise more
Thanks
RE: UG NX3 Error
Can you re-direct me to thread?
Thanks