Working with Subweldments on cutlists
Working with Subweldments on cutlists
(OP)
OK guys, not very familiar with sub-weldments and the SW help doc for what I want to do is basically non-existent. On the attached file I'm trying to create a series of sub-weldments for the four parts in Cut-List-Item26. they are all the same channel with different position and slightly different orientation in some cases. I want to create a sub-weldment to have fabrication precutting this piece in bulk, then have the cut list display Qty(4) of the part. I can get the sub-weldments of the individual parts created but cannot combined all four sub-weldments into one cut list item. If I have to list them as four different line items, but it would be cleaner if they were all one.
Joe Hasik, CSWP/SMTL
SW 09 x64, SP 1.0
Dell T3400
Intel Core2 Quad
Q6700 2.66 GHz
3.93 GB RAM
NVIDIA Quadro FX 4600





