FT&A
FT&A
(OP)
Is it possible to get constructed geometry ( passing planes in this case) to show when I display a capture? I have used capture management, shown it while active in the capture, tried the constructed geometry management, etc. I can associate tolerances and dimensions to them, but when I display a capture they would be more helpful visualized.





RE: FT&A
RE: FT&A
Chris
SolidWorks/PDMWorks 08 3.1
AutoCAD 08; CATIA V5
ctopher's home (updated Aug 5, 2008)
ctopher's blog
SolidWorks Legion
RE: FT&A