Adding Groups to Family Tables
Adding Groups to Family Tables
(OP)
I have a large assembly with 2 different versions. I have all the components shown in the generic and two instances. I would like to simplify my family table by grouping. Group 1 is shown in instance 1 and group 2 is shown in instance 2.
I can add components to the family table, but when I click on the groups option I get the 'no group found' error. Does anyone know how I add a group to a family table?
I can add components to the family table, but when I click on the groups option I get the 'no group found' error. Does anyone know how I add a group to a family table?





RE: Adding Groups to Family Tables
I had a family table of an asembly, over 100 componnets. I grouped them by length in WF2 and we couldn't open the instances. Opened the file in WF5 and at the end of the family table were the groups, all set to N. Chnaged them to Y and I could open an instance. In WF2, I ungrouped everything and the instances can now be opened.
Be careful what you ask for!
"Wildfires are dangerous, hard to control, and economically catastrophic."
Ben Loosli
RE: Adding Groups to Family Tables
RE: Adding Groups to Family Tables
Thanks
RE: Adding Groups to Family Tables