Synchronous Technology Not Behaving
Synchronous Technology Not Behaving
(OP)
Hi people
Please will someone tell me where I'm going wrong with this NX6 part. It was demonstrated to me a few times by Siemens and I've had a go at modelling something similar myself. I pasted body (19) into the model and successfully added symmetry around the YZ plane of DATUM_CSYS (0) followed by a single linear dimension from the YZ plane to one edge which controls the width of the 'pad' whilst maintaining symmetry. However, when I've tried to add a linear dimension from Datum Plane (24) to an edge or even pulling one of the faces, it will not, no matter what I've tried retain symmetry. Even the results tab of the face finder is empty which tells me it has not found the other face.
Please help me as it's driving me insane!!!!!!!
Please will someone tell me where I'm going wrong with this NX6 part. It was demonstrated to me a few times by Siemens and I've had a go at modelling something similar myself. I pasted body (19) into the model and successfully added symmetry around the YZ plane of DATUM_CSYS (0) followed by a single linear dimension from the YZ plane to one edge which controls the width of the 'pad' whilst maintaining symmetry. However, when I've tried to add a linear dimension from Datum Plane (24) to an edge or even pulling one of the faces, it will not, no matter what I've tried retain symmetry. Even the results tab of the face finder is empty which tells me it has not found the other face.
Please help me as it's driving me insane!!!!!!!
Best regards
Simon (NX4.0.4.2 MP9 - TCEng 9.1.3.6.c)
www.jcb.com
Life shouldn't be measured by the number of breaths you take, but by the number of times when it's taken away...





RE: Synchronous Technology Not Behaving
Best regards
Simon (NX4.0.4.2 MP9 - TCEng 9.1.3.6.c)
www.jcb.com
Life shouldn't be measured by the number of breaths you take, but by the number of times when it's taken away...