no flat face in imported step or igs file
no flat face in imported step or igs file
(OP)
Hi all, good day!!!
I am suffering from not being able to get flat face in imported igs or step files.
Original UG file contains flat faces. after importing I cann't use them for assembly because they are not considered flat faces any more. Also I cann't create sketch on the surface. If I measuer one of them, CATIA shows surface symbol instead of face.
I have tried to modify igs settings, it didn't work.
Anyone can tell me how to solve the problem?
I am suffering from not being able to get flat face in imported igs or step files.
Original UG file contains flat faces. after importing I cann't use them for assembly because they are not considered flat faces any more. Also I cann't create sketch on the surface. If I measuer one of them, CATIA shows surface symbol instead of face.
I have tried to modify igs settings, it didn't work.
Anyone can tell me how to solve the problem?
Forever Young.....





RE: no flat face in imported step or igs file
We typically use step to transfer files from UG - Catia.
Regards,
Derek
RE: no flat face in imported step or igs file
Forever Young.....