Postbuilder help. Helix output vs. Linear
Postbuilder help. Helix output vs. Linear
(OP)
Hi there,
I am using NX5 and PB 5.0.3.
I need to get the post to output regular helix moves rather than linear moves.
The linear moves are too memory intensive for some of our older controls.
What do I need to look at to get an XYZR move?(or XYZIJK..)
J
I am using NX5 and PB 5.0.3.
I need to get the post to output regular helix moves rather than linear moves.
The linear moves are too memory intensive for some of our older controls.
What do I need to look at to get an XYZR move?(or XYZIJK..)
J





RE: Postbuilder help. Helix output vs. Linear
From Post builder you can import this to output helical motion.
When you import it read the instructions.
It should be in \NX 5.0\POSTBUILD\pblib\custom_command
John Joyce
Tata Technologies iKS
1675 Larimer St.
Denver, CO
www.myigetit.com
RE: Postbuilder help. Helix output vs. Linear
I remember it being something simple like that but I could not for the life of me figure it out!
Thanks!