Installation
Installation
(OP)
I have just had to reinstall Solid Works 2001 and have the following problem - When i draw a rectangle using
sketch and then try to extrude it everything locks
up. I am running windows 98.
I have had this problem before and I think I
fixed it using options but so long ago i cannot remember
how !!!
Can any one help
sketch and then try to extrude it everything locks
up. I am running windows 98.
I have had this problem before and I think I
fixed it using options but so long ago i cannot remember
how !!!
Can any one help






RE: Installation
Are you running a virus protect when you install SW? This is a bad thing to do when installing SW.
You will need to list the rest of your Hardware for us to better help you.
I hope that helps somewhat,
Scott Baugh, CSWP
credence69@REMOVEhotmail.com
http://home.insightbb.com/~scott.baugh/