NX6 crashes on Macpro running under bootcamp.
NX6 crashes on Macpro running under bootcamp.
(OP)
NX6 is crashing when I try to add a component under assemblies. Assemblies worked fine when I was using NX5. I have no apparent problems with other modules of NX6, such as, modeling and electrical data exchange. I am modeling circuit boards. Any suggestions?
NX6 is running fine on the Windows machines on our network.
NX6 is running fine on the Windows machines on our network.





RE: NX6 crashes on Macpro running under bootcamp.
But remember, officially Siemens PLM does NOT yet support any Intel-based Mac configurations irrespective of the OS that you're running.
John R. Baker, P.E.
Product 'Evangelist'
NX Design
Siemens PLM Software Inc.
Cypress, CA
http://www.siemens.com/plm
http://www.plmworld.org/museum/
To an Engineer, the glass is twice as big as it needs to be.
RE: NX6 crashes on Macpro running under bootcamp.