Dilemma
Dilemma
(OP)
I carry a substantial experience in CAD using Inventor & CATIA. Never had a chance to work in Solidworks, I have two job leads that require that. I know its not easy to satisfy the employer, specially HR personnel upfront that carrying on tasks on any other CAD package is pretty similar, just the interface difference. But I see in the economy everyone wanst results right away.
But is there a cheaper way (on my own)to attain the expertise.
But is there a cheaper way (on my own)to attain the expertise.






RE: Dilemma
Great thread title. Really descriptive of you problem statement.
Check with a SWx VAR to obtain a trial version.
RE: Dilemma
Best of Luck.
Kyle Chandler
www.chiefengineering.net
RE: Dilemma
Nice, I can ask my friend's nephew he is in school.
rollupswx,
sorry I apologize for being non descriptive in my thread title. Thanks for the advise.
RE: Dilemma
http://www.fcsuper.com/swblog/?p=29
Matt Lorono
CAD Engineer/ECN Analyst
Silicon Valley, CA
Lorono's SolidWorks Resources
Co-moderator of Solidworks Yahoo! Group
and Mechnical.Engineering Yahoo! Group
RE: Dilemma
RE: Dilemma
The editorial review does state: but how do you get that card?
The Edge... there is no honest way to explain it because the only people who really know where it is are the ones who have gone over. - Hunter S. Thompson
RE: Dilemma
RE: Dilemma
RE: Dilemma
As for Inventor and Catia...I have found SW to be the easiest to use. If you can use either of those others, you will have no problems using SW.
Ken