Sheet Metal Draft
Sheet Metal Draft
(OP)
I'm working in SolidEdge ST, but in traditional mode for sheet metal. I created some parts, but for making draft...How do I mark the lines for then bends on the flatten view.
ANd when we are doing that, can we make it dotted line??
Thanks!!!
Hope you can help me
Ing. Efren Ramirez
ANd when we are doing that, can we make it dotted line??
Thanks!!!
Hope you can help me
Ing. Efren Ramirez





RE: Sheet Metal Draft
thread562-231085: Lofted Non-Tangent Arc-Lines and Flat Pattern Bend Lines
bc.
2.4GHz Core2 Quad, 4GB RAM,
Quadro FX4600.