Assemble vs Add
Assemble vs Add
(OP)
I looked for an answer in old topics but didn't find an answer.
Is there a differance between assemble and add in part design? I was told to use assemble when at all possible and use negative bodies also. I have been asked but others here why and I didn't have a good answer other than "because".
Ross.
Is there a differance between assemble and add in part design? I was told to use assemble when at all possible and use negative bodies also. I have been asked but others here why and I didn't have a good answer other than "because".
Ross.





RE: Assemble vs Add
This is extremely powerful in advanced functionality, including PowerCopies, User Defined Features, etc.
RE: Assemble vs Add
Most of the time I am just adding two physical (positive?) part bodies together.
I think I understand, but could you give me an example?
Sorry to jump in on your question Ross, but I was wondering the same thing just the other day.
--Jay
RE: Assemble vs Add
http://www.eng-tips.com/viewthread.cfm?qid=152895
RE: Assemble vs Add
http
RE: Assemble vs Add
RE: Assemble vs Add
http://www.eng-tips.com/viewthread.cfm?qid=135059
/k.c.takacs