creating a cylinder
creating a cylinder
(OP)
Hello
I am wondering how to create a cylinder which base is on X-Z plane? Ansys assumes the base in on X-Y plane.
Thanks a lot for your generous help.
Amin
I am wondering how to create a cylinder which base is on X-Z plane? Ansys assumes the base in on X-Y plane.
Thanks a lot for your generous help.
Amin





RE: creating a cylinder
try to set (rotate, move) workplane to global x-z plane.
Check the ansys manual for commands:
WPOFFS, XOFF, YOFF, ZOFF
WPROTA, THXY, THYZ, THZX