Shot Peened Inside (Hammer Finish) on 6063-T6 aluminum
Shot Peened Inside (Hammer Finish) on 6063-T6 aluminum
(OP)
Hi,
Our customer has a 6063-T6 aluminum pipe specification for the resin pellet transport asking that all pipe, elbow, etc. shall be shot peened inside (hammer finish). What are the advantages to do this kind of treatment? Also, what is the differences between mechanical or chemical to realize this finish?
Regards,
Hcjulien
Our customer has a 6063-T6 aluminum pipe specification for the resin pellet transport asking that all pipe, elbow, etc. shall be shot peened inside (hammer finish). What are the advantages to do this kind of treatment? Also, what is the differences between mechanical or chemical to realize this finish?
Regards,
Hcjulien





RE: Shot Peened Inside (Hammer Finish) on 6063-T6 aluminum
RE: Shot Peened Inside (Hammer Finish) on 6063-T6 aluminum
is it done chemically or mechanically?
Regards,
hcjulien
RE: Shot Peened Inside (Hammer Finish) on 6063-T6 aluminum
http:/
RE: Shot Peened Inside (Hammer Finish) on 6063-T6 aluminum
What's the ID of the pipe?