Viewable Part Sketches
Viewable Part Sketches
(OP)
SW08 SP5
How do you get sketches to show in parts, so you can use their geometry for other features? I have a conical revolve that I want to place a plane on. I know I can select the conical face and a standard plane to create a new plane, that works. I would rather build some sketches in the part and use that geometry to create the plane, as I have a feeling this plane will become independent of the conical face as the part evolves.
I am thinking there is some enabled option that I am missing, but I can't find it.
How do you get sketches to show in parts, so you can use their geometry for other features? I have a conical revolve that I want to place a plane on. I know I can select the conical face and a standard plane to create a new plane, that works. I would rather build some sketches in the part and use that geometry to create the plane, as I have a feeling this plane will become independent of the conical face as the part evolves.
I am thinking there is some enabled option that I am missing, but I can't find it.






RE: Viewable Part Sketches
Dan
www.eltronresearch.com
Dan's Blog
RE: Viewable Part Sketches
Jeff Mowry
www.industrialdesignhaus.com
A people who value security over freedom will soon find they have neither.
RE: Viewable Part Sketches
I was sitting here like fool, right-clicking the sketch and toggling between Show and Hide.
*kneeling and bowing* I'm not worthy, I'm not worthy...
RE: Viewable Part Sketches
Jeff Mowry
www.industrialdesignhaus.com
A people who value security over freedom will soon find they have neither.
RE: Viewable Part Sketches
Been there and done that enough times that I finally added the buttons to the view toolbar. But I still do it on a regular basis...
Joe
SW Office 2008 SP4.0
P4 3.0Ghz 3GB
ATI FireGL X1