SW 2009 QUESTION-PART DISPLAY IN ASSEMBLY
SW 2009 QUESTION-PART DISPLAY IN ASSEMBLY
(OP)
When I open a parasolid file in 2009 as an assembly,It doesn't retain its original part colors. Once it finished loading the whole assembly changes to Grey.
If I open the same parasolid file in 2008, all individual parts retains its original colors.
Is there any settings in SW 2009 to maintain its original colors when it is shaded?
Thanks
If I open the same parasolid file in 2008, all individual parts retains its original colors.
Is there any settings in SW 2009 to maintain its original colors when it is shaded?
Thanks






RE: SW 2009 QUESTION-PART DISPLAY IN ASSEMBLY
RE: SW 2009 QUESTION-PART DISPLAY IN ASSEMBLY
I don't think it is the realview issue.
There may be some other settings controls this issue.
Please see the attachments.
Any suggestions,
Thanks
RE: SW 2009 QUESTION-PART DISPLAY IN ASSEMBLY
RE: SW 2009 QUESTION-PART DISPLAY IN ASSEMBLY
I too am having this problem but I'm running 2008 sp4.0. I didn't have this on sp3.1. I've contacted my VAR and they told me it was supposed to be fixed in 2009. I guess this is not the case. Maybe it'll be fixed is sp1.0.
RE: SW 2009 QUESTION-PART DISPLAY IN ASSEMBLY
Let's hope that this will be fixed in sp1