NXi 6m1
NXi 6m1
(OP)
Does any one have an idea when the m1 release will be availble for NX Ideas 6 ?
INTELLIGENT WORK FORUMS
FOR ENGINEERING PROFESSIONALS Come Join Us!Are you an
Engineering professional? Join Eng-Tips Forums!
*Eng-Tips's functionality depends on members receiving e-mail. By joining you are opting in to receive e-mail. Posting GuidelinesJobs |
|
RE: NXi 6m1
Have you ran into bugs?
I have NXI6 installed and can't say there is really any difference from 12m4
RE: NXi 6m1
I have always waited for the first m release before moving and just wondered if there was any idea of when 6m1 would be availble
RE: NXi 6m1
Siemens usually doesn't make announcements for target release dates of bug fixes (maintenance releases), unless you ask a Siemens employee on the bbsnotes boards. They usually just send out a SFB informing subscribers that the new maintenance release is available for download.
There are I-DEAS only newsgroups available on bbsnotes, which is where I would ask this very question if I was really really wanting to know. You'll need to create a webkey account in order to access the newsgroups. If you need further help, post back in this thread and I can try to assist you.
Tim Flater
Senior Designer
Enkei America, Inc.
www.enkei.com
Some people are like slinkies....they don't really have a purpose, but they still bring a smile to your face when you push them down the stairs.
RE: NXi 6m1
RE: NXi 6m1
If you are looking to migrate from I-DEAS to NX, I can say it looks pretty promising. I have used the CMM in Native mode (no teamcenter installation, just reads out of the TDM and outputs NX files). All of what i tried so far has almost been 100% perfect, and what little things that did come up were not an issue. Also all of was i migrated was parts, assemblies and drawing of pretty prismatic parts.
RE: NXi 6m1