delete face in NX4?
delete face in NX4?
(OP)
I cannot find the EDIT - EDIT FACE command in NX4. I have found replace face in DIRECT MODELING. A must have when working with dumb solids.
INTELLIGENT WORK FORUMS
FOR ENGINEERING PROFESSIONALS Come Join Us!Are you an
Engineering professional? Join Eng-Tips Forums!
*Eng-Tips's functionality depends on members receiving e-mail. By joining you are opting in to receive e-mail. Posting GuidelinesJobs |
|
RE: delete face in NX4?
John R. Baker, P.E.
Product 'Evangelist'
NX Design
Siemens PLM Software Inc.
Cypress, CA
http://www.siemens.com/plm
http://www.plmworld.org/museum/
To an Engineer, the glass is twice as big as it needs to be.
RE: delete face in NX4?
This is one of the few case when NX was able to consolidate functions by getting rid of duplication. Since the older function did not create a feature there was no legacy to be hung up on!
In any case the name has eventually stayed the same but the underlying method is completely changed for the better.
Cheers
Hudson
RE: delete face in NX4?
In NX 3 and NX 4, Delete Face is where it's always been, at...
Edit -> Face...
Starting in NX 5, the Delete Face function was moved to the Direct Modeling tool set, which of course in NX 6 now comes under the umbrella of Synchronous Modeling.
John R. Baker, P.E.
Product 'Evangelist'
NX Design
Siemens PLM Software Inc.
Cypress, CA
http://www.siemens.com/plm
http://www.plmworld.org/museum/
To an Engineer, the glass is twice as big as it needs to be.
RE: delete face in NX4?