CONTA175/TARGE169
CONTA175/TARGE169
(OP)
Hello everybody
I re-simulated this simple problem:
http:// www.mece.u alberta.ca /tutorials /ansys/AT/ Contact/Co ntact.html
and my ANSYS11.0 run very well and contact happened between the beams. I am wondering why no contact happened when I run the problem with no gap between the beams?
Thank you in advance :)
I re-simulated this simple problem:
http://
and my ANSYS11.0 run very well and contact happened between the beams. I am wondering why no contact happened when I run the problem with no gap between the beams?
Thank you in advance :)





RE: CONTA175/TARGE169
Thanks
Amin
RE: CONTA175/TARGE169