Plastic/Steel Press Fit Interference
Plastic/Steel Press Fit Interference
(OP)
First post on these boards. It seems like there's a great group of people here.
I have an application where I'd like to press a molded Polypropylene GF30 piece onto a square steel shaft (about 3/8").
Does anyone know of any design rules of thumb for interference?
Thanks.
I have an application where I'd like to press a molded Polypropylene GF30 piece onto a square steel shaft (about 3/8").
Does anyone know of any design rules of thumb for interference?
Thanks.






RE: Plastic/Steel Press Fit Interference
Regards
eng-tips, by professional engineers for professional engineers
Please see FAQ731-376: Eng-Tips.com Forum Policies for tips on how to make the best use of Eng-Tips Fora.