×
INTELLIGENT WORK FORUMS
FOR ENGINEERING PROFESSIONALS

Log In

Come Join Us!

Are you an
Engineering professional?
Join Eng-Tips Forums!
  • Talk With Other Members
  • Be Notified Of Responses
    To Your Posts
  • Keyword Search
  • One-Click Access To Your
    Favorite Forums
  • Automated Signatures
    On Your Posts
  • Best Of All, It's Free!
  • Students Click Here

*Eng-Tips's functionality depends on members receiving e-mail. By joining you are opting in to receive e-mail.

Posting Guidelines

Promoting, selling, recruiting, coursework and thesis posting is forbidden.

Students Click Here

Jobs

PRETS179

PRETS179

PRETS179

(OP)
Hi,

How properly constrain model including PRETS179 element to be converged? I`m trying to avoid this message...

Preconditioned conjugate gradient solver error level 1.  Possibly, the model is unconstrained or additional iterations may be needed.  Try running with a multiplier MULT > 1 in EQSLV command (3 > MULT > 1).

but the only way is to constrain it (all DOF = 0) in both sides where pretension is acting... :(

Thanks,
Lukasz

RE: PRETS179

Your model is trying to fly apart because of poor initial conditions. Try attaching weak springs to your structure (and constrain them) and then solve.


------------
See FAQ569-1083: Asking questions the smart way on Eng-Tips fora for details on how to make best use of Eng-Tips.com

RE: PRETS179

Also, don't forget that you need to consider the pre-tension node.

From ANSYS help:

"The pretension node K has only one translation degree of freedom UX, which defines the relative displacement between the two sections A and B in the pretension load direction. Sliding motion is prevented automatically. If the pretension node and the bolted structure are not well constrained, rigid body motion can occur. Therefore, in the beginning of each load step, you should verify the boundary conditions for bolt structures carefully."


------------
See FAQ569-1083: Asking questions the smart way on Eng-Tips fora for details on how to make best use of Eng-Tips.com

RE: PRETS179

Hi,
in addition, consider that the pretension elements are not the whole problem: if you want to model a preloaded bolt with the PRETS179, you also have to setup the proper Contact Pairs for the areas of the bolt/flanges interfaces. I suspect you are missing some...

Regards

Red Flag This Post

Please let us know here why this post is inappropriate. Reasons such as off-topic, duplicates, flames, illegal, vulgar, or students posting their homework.

Red Flag Submitted

Thank you for helping keep Eng-Tips Forums free from inappropriate posts.
The Eng-Tips staff will check this out and take appropriate action.

Reply To This Thread

Posting in the Eng-Tips forums is a member-only feature.

Click Here to join Eng-Tips and talk with other members!


Resources