R18 Drafting, Leader Tail not Scaling
R18 Drafting, Leader Tail not Scaling
(OP)
Hi All,
Just loaded R18 last week, and today I begin a drawing. The Heads on my leaders seem to scale to proper size in the views I am working however the tails do not. I can not find the setting in the standards file to change this. Any help would be appriciated. Using a custom but ASME derived standard.
Just loaded R18 last week, and today I begin a drawing. The Heads on my leaders seem to scale to proper size in the views I am working however the tails do not. I can not find the setting in the standards file to change this. Any help would be appriciated. Using a custom but ASME derived standard.
Wes C.
------------------------------
No trees were killed in the sending of this message, but a large number of electrons were terribly inconvenienced.




