Enhanced Scenes Updating
Enhanced Scenes Updating
(OP)
I've created 5 enhanced scenes for an assembly.
Geometry was modified on one part. Another part was
coincident to this modified part. Of course when I updated
the assembly the coincident parts mated together.
But the enhanced scenes did not show the update.
How would I update the enhanced scenes?
Thanks.
Geometry was modified on one part. Another part was
coincident to this modified part. Of course when I updated
the assembly the coincident parts mated together.
But the enhanced scenes did not show the update.
How would I update the enhanced scenes?
Thanks.





RE: Enhanced Scenes Updating
RE: Enhanced Scenes Updating
If you have created an Full Enhanced scene (shown in the tree by a red coordinatesystem instead of black when partial scene, sometimes you need to convert it with this steps:
1) Select the scene in the tree
2) Run Enhance scene-icon
3) Make sure it is partial selected in dialogbox.
You have now created a partial from the full, so you can delete the full scene.
Good luck
RE: Enhanced Scenes Updating
I now understand more of enhanced scenes.
RE: Enhanced Scenes Updating
thixoguy