Cosmetic threads on 1/2 part
Cosmetic threads on 1/2 part
(OP)
How do I create a cosmetic thread on half a cylinder?
I have a 1/2 of sleeve/disk modeled and when i add the cosmetic thread, it will revolve 360 degrees around instead of the 180 deg. I tried cutting it with an extrusion and it wont go away. Eventually i need to add a rectangular plate on the bottom of the 1/2 disk
thanks guys
I have a 1/2 of sleeve/disk modeled and when i add the cosmetic thread, it will revolve 360 degrees around instead of the 180 deg. I tried cutting it with an extrusion and it wont go away. Eventually i need to add a rectangular plate on the bottom of the 1/2 disk
thanks guys





RE: Cosmetic threads on 1/2 part
--
Fighter Pilot
Manufacturing Engineer
RE: Cosmetic threads on 1/2 part
But what else can i trim with this feature. I noticed that it was grayed out (unavailable) when the cosmetic threads wasnt there.
RE: Cosmetic threads on 1/2 part
--
Fighter Pilot
Manufacturing Engineer