views not updating ....
views not updating ....
(OP)
people.
NX4.0.4.2 MP6
from Tceng I keep retrieving an Assembly specification in NX4 and the views are not correct for a part used ... in fact the model itself does not reflect the piece part. WAVE has been used and when I make the part - the displayed part - close and re-open - all seems to correct itself in the assembly model.
I go back to the specification, update the views - the Xha does whatever it wants ( much editing again )...
please say this is user error, or a simple switch somewhere. currently every time I open the drawing I end up editing xha .... crazy
hope the experts amongst you understand the dilema ..
gary
NX4.0.4.2 MP6
from Tceng I keep retrieving an Assembly specification in NX4 and the views are not correct for a part used ... in fact the model itself does not reflect the piece part. WAVE has been used and when I make the part - the displayed part - close and re-open - all seems to correct itself in the assembly model.
I go back to the specification, update the views - the Xha does whatever it wants ( much editing again )...
please say this is user error, or a simple switch somewhere. currently every time I open the drawing I end up editing xha .... crazy
hope the experts amongst you understand the dilema ..
gary





RE: views not updating ....
Update views. If you still don't get then try this
In the specification file, MB3 the assembly->properties->In "Assembly" tab click "Display" button
Update views.
RE: views not updating ....
regards ... gary