Parts Lists
Parts Lists
(OP)
Hello, I was just wondering if anyone knew if there is a way to have one common parts list for two different assemblies in one drwaing. These assemblies have common parts and I would like to have them counted in one parts lists. Any ideas?





RE: Parts Lists
I don't know how the balloon numbing will worf if you're not using different View Representations of the new assembly, to get trimmed down views of the 2 lower level assemblies.
Never tried this method in Inventor, but maybe this will help.
Ken
RE: Parts Lists
RE: Parts Lists
RE: Parts Lists
I't basically allows you to quickly remove a bunch of parts from an assembly so you can work faster because those parts are unloaded from memory when you activate a LOD.
RE: Parts Lists
The problem with putting the two individual assemblies in the drawing sheet separately is that the title block pulls through the iProps from the first assembly, and you can not obtain any detail from the second assembly.... but you've probably figured that out already.