Any books on automotive wheel design?
Any books on automotive wheel design?
(OP)
Does anyone know of any books or resources on automotive wheel designing and production?
I want to design a few a 3 piece and one piece wheels on solidworks, I was looking at forged 6061 T6 aluminum.
What are some good books and resources that I should/could use so this will materialize into a safe usable design?
I will be ordering the handbook from Tire and Rim Association.
Any input will be highly appreciated.
I want to design a few a 3 piece and one piece wheels on solidworks, I was looking at forged 6061 T6 aluminum.
What are some good books and resources that I should/could use so this will materialize into a safe usable design?
I will be ordering the handbook from Tire and Rim Association.
Any input will be highly appreciated.





RE: Any books on automotive wheel design?
Cheers
Greg Locock
SIG:Please see FAQ731-376: Eng-Tips.com Forum Policies for tips on how to make the best use of Eng-Tips.
RE: Any books on automotive wheel design?
The ductility of forged 6061-T6 wheels exceeds the ductility of cast 356-T6 wheels: 10 % elongation vs. 7 %.
I know of no book on this subject. Other good resources are SAE Technical Papers and SAE Standards. These are all available as downloads (you have to pay for them) at the SAE International Internet site:
http://www.sae.org
2004-01-1578 Development of the SAE Biaxial Wheel Test Load File
2001-01-0749 The Design and Processing of Cast Aluminum Wheels for Impact Performance
SAE J2530 Aftermarket Wheels - Passenger Cars and Light Truck -Performance Requirements and Test Procedures
SAE J328 Wheels--Passenger Car and Light Truck Performance Requirements and Test Procedures
SAE J175 Wheels-Impact Test Procedures-Road Vehicles
SAE J1095 Spoke Wheels and Hub Fatigue Test Procedures
SAE J2562 Biaxial Wheel Fatigue Test
Regards,
Cory
Please see FAQ731-376: Eng-Tips.com Forum Policies for tips on how to make the best use of Eng-Tips Fora.
RE: Any books on automotive wheel design?