autoballoon issue
autoballoon issue
(OP)
Hi,
I wonder if you could help me. Imagine that you have a drawing with balloons according to the parts list. It will only show one balloon for every component type. Is it somehow possible to change the settings so, that it would show all the occurences of the current part?
I am using NX 4.02
Thanks for help
Vit
I wonder if you could help me. Imagine that you have a drawing with balloons according to the parts list. It will only show one balloon for every component type. Is it somehow possible to change the settings so, that it would show all the occurences of the current part?
I am using NX 4.02
Thanks for help
Vit





RE: autoballoon issue
John R. Baker, P.E.
Product 'Evangelist'
NX Design
Siemens PLM Software Inc.
Cypress, CA
http://www.siemens.com/plm
http://www.plmworld.org/museum/
To an Engineer, the glass is twice as big as it needs to be.
RE: autoballoon issue
RE: autoballoon issue
John R. Baker, P.E.
Product 'Evangelist'
NX Design
Siemens PLM Software Inc.
Cypress, CA
http://www.siemens.com/plm
http://www.plmworld.org/museum/
To an Engineer, the glass is twice as big as it needs to be.
RE: autoballoon issue
Thanks John
Regards
Vit