ANSYS Intersections
ANSYS Intersections
(OP)
Using ADPL is there a command that would detect intersections of lines?
Say I have a line, and I draw a circle through the line (hitting 1 or 2 points), is there a way to get which line that is being intersected? (I don't care if it hits once or twice, just that it hits.)
Thanks
Say I have a line, and I draw a circle through the line (hitting 1 or 2 points), is there a way to get which line that is being intersected? (I don't care if it hits once or twice, just that it hits.)
Thanks





RE: ANSYS Intersections
try LINL.
Alex