unfolding sheetmetal v5r18
unfolding sheetmetal v5r18
(OP)
Hi,
When I insert an unfolded view of a part into a drawing, I'm losing all of the holes I created in that part at the assembly level. I didn't have this problem in R17 but I recently got upgraded to R18. I'd appreciate any help.
Thanks!!
When I insert an unfolded view of a part into a drawing, I'm losing all of the holes I created in that part at the assembly level. I didn't have this problem in R17 but I recently got upgraded to R18. I'd appreciate any help.
Thanks!!




