Toolbox issue - "___" is already opened
Toolbox issue - "___" is already opened
(OP)
One of my users is getting a warning when he tries to insert a screw into his assembly. He gets the following warning message:
A document named "Flat Head Screw_AI" is already opened. Do you want to show this already-opened document?
He only has his one large assembly open, nothing else is open that we can tell.
Any suggestions?
A document named "Flat Head Screw_AI" is already opened. Do you want to show this already-opened document?
He only has his one large assembly open, nothing else is open that we can tell.
Any suggestions?






RE: Toolbox issue - "___" is already opened
Do a search on the assy, or use the Find References option.
RE: Toolbox issue - "___" is already opened
- insert Documents as read only
- always change read only status of document before writing
are selected in the toolbox properties.Eric