Idiots guide to riveting
Idiots guide to riveting
(OP)
Other than the obvious Machineries Handbook, anyone know of any good online guides to riveting?
An intern I'm not supervising is looking at riveting some clips to a 'base board' type part. Similar to what you see on the bottom of fridges etc.
I'm looking to give him some information, sadly his supervisor is electrical and I don't have time to help (plus my help may not be appreciated) and I've forgotten much of what little I used to know. (And I don't have the rivet catalogues anymore.)
I found the link immediately below and the you tube was posted a while back.
http://www.hansonrivet.com/w13.htm
http://www.youtube.com/watch?v=5DVPG8go4Jk
Thanks for any suggestions.
An intern I'm not supervising is looking at riveting some clips to a 'base board' type part. Similar to what you see on the bottom of fridges etc.
I'm looking to give him some information, sadly his supervisor is electrical and I don't have time to help (plus my help may not be appreciated) and I've forgotten much of what little I used to know. (And I don't have the rivet catalogues anymore.)
I found the link immediately below and the you tube was posted a while back.
http://www.hansonrivet.com/w13.htm
http://www.youtube.com/watch?v=5DVPG8go4Jk
Thanks for any suggestions.
KENAT, probably the least qualified checker you'll ever meet...





RE: Idiots guide to riveting
Pages 3213, 3217 (etc) have similar info.
"Art without engineering is dreaming; Engineering without art is calculating."
Have you read FAQ731-376: Eng-Tips.com Forum Policies to make the best use of Eng-Tips Forums?
RE: Idiots guide to riveting
Chapter 4 has a bunch of stuff on rivets.
htt
RE: Idiots guide to riveting
KENAT, probably the least qualified checker you'll ever meet...