Extrude Bug!!!
Extrude Bug!!!
(OP)
Hi all,
I created an extrude with Until Next option, see the attached file. I was expecting it will select the face of white colored block (first solid body), but it has selected the face of last solid body!!!
I created an extrude with Until Next option, see the attached file. I was expecting it will select the face of white colored block (first solid body), but it has selected the face of last solid body!!!





RE: Extrude Bug!!!
RE: Extrude Bug!!!
In fact I went into Edit, and changed the end option from Until Next to Value and then back to Until Next and it stopped right where you wanted it, as seen in my attached example.
John R. Baker, P.E.
Product 'Evangelist'
NX Design
Siemens PLM Software Inc.
Cypress, CA
http://www.siemens.com/plm
http://www.plmworld.org/museum/
RE: Extrude Bug!!!
RE: Extrude Bug!!!
RE: Extrude Bug!!!
RE: Extrude Bug!!!
RE: Extrude Bug!!!
That's about the only time that I use it either
I tried to test for this post NX-4.0.4.2 and it seemed to work just fine, using either your test part or one I created. Just using until selected can't hurt.
Best Regards
Hudson