Bulk change Units decimal places
Bulk change Units decimal places
(OP)
Is there a macro to bulk change "Tools/Options/Document Properties/Units decimal places" (Length/Dual/Angular/Mass) in all the parts in an assembly?
In my BOM, if I call for the density, it shows only 2 decimal places in that column and it is not accurate enough. I want to increase it up to 4 to show 0.0078g/mm^3 where as now it shows as 0.01g/mm^3.
In my BOM, if I call for the density, it shows only 2 decimal places in that column and it is not accurate enough. I want to increase it up to 4 to show 0.0078g/mm^3 where as now it shows as 0.01g/mm^3.
Michael Fernando CSWP
Tool and Die Designer
SWX 2007 SP5.0 X64
PDMWorks 2007
Logopress3
FastForm Advance
FormatWorks





