Qualifying Stainless Steel Weld Procedures.
Qualifying Stainless Steel Weld Procedures.
(OP)
I'm on an oil & gas project and we have stainless steel types, 304H, 304L, 316, 316L, & 321.
As these types are all P8 Group 1, could weld procedure qualification in one type, qualify all types and satisfy ASME IX requirements?
If so, which type is recommended to be used for the qualification?
As these types are all P8 Group 1, could weld procedure qualification in one type, qualify all types and satisfy ASME IX requirements?
If so, which type is recommended to be used for the qualification?





RE: Qualifying Stainless Steel Weld Procedures.
Joe Tank