Solid Works 2008X64 unable to open master db
Solid Works 2008X64 unable to open master db
(OP)
We are getting the message:
"Unable to open master db due to the following db
access error"
This is on service pack 3
Until 2 days ago, the pc had been running this for over a month.
I have unloaded, removed registry entries and re-loaded.
Same problem.
"Unable to open master db due to the following db
access error"
This is on service pack 3
Until 2 days ago, the pc had been running this for over a month.
I have unloaded, removed registry entries and re-loaded.
Same problem.





